چنل استریپ RUPERT NEVE PORTICO II CHANNEL
چنل استریپ RUPERT NEVE PORTICO II CHANNEL
چنل استریپ دست ساز فوق حرفه ای با رزولیشن بی نظیر از تولیدات بزرگ کمپانی راپرت نیو
متشکل از اکولایزر و کمپرسور و امکان جا به جایی ترتیب هر دو دی ایزر برای کنترل محدوده های فرکانس روی حروف (سین و شین و ...)
و امکان بلند ترکیب ماتریکس اعمال کمپ و اف اف و اف بی برای صحولت در نرم کردن اتک ریلیز و دیگر جزاء
محصول امریکا در سطح کلاس Class A در رده چنل استیپ ها بسیار رنگ صدای استاندارد شفاف و حجیمی را به شما میبخشد
دست ساز ساخت امریکا Hand Made , Made In USA
Texture
Continuously variable control for Silk and Silk+ modes allows the engineer to fine tune the harmonic ratio and tonality of the channel.
Post Comp
Moves the EQ after the Compressor
De-Esser
Tunable with the HMF EQ bandwidth reduction, the multi-variable De-Esser can be used to soften harsh sibilance in voices and instruments
Blend
A parallel matrix providing continuously variable control to mix compressed and uncompressed signals
FF/FB
Changes the VCA Detection from a forward feed design (fast, more accurate attack & release) to a feed back design (smoother, more musical response)
RMS / Peak
Overrides the attack setting, using a combination of peak and RMS detection set below 1ms
Side Chain Send/Return
External compressor side chain send and return on 2 x TRS jacks. The send is always active and normalled to the return (NOTE: If the send and return are connected to a patchbay, the send should be normalled or connected to the return by default, as the compressor will not trigger if the return has no signal)
Meters
Dual 16 point peak meters display compressor (not de-esser) gain reduction and output levels
High Pass Filter
Continuously variable from 20-250Hz
HPF to Side Chain
Uses the HPF in the Compressor Side Chain
Gain
Provides 66dB in 6dB steps
Trim
Continuous +/- 6dB level contro
Phase Inverts
Reverses the polarity of the signal
Phantom Power
Selectable 48V for powering microphones
DI
Discrete FET input for Hi-Z instruments
Line Input
Selectable +4 balanced input
LF EQ
+/-15dB adjustment at 35, 60, 100, and 220 Hz, independent LF engage, selectable classic bell or accelerated shelf curves
LMF EQ
+/-15dB adjustment from 70 to 1.4KHz, with a continuous "Q" from .7 to 5., engaged with the MF switch.
HMF EQ
+/-15dB adjustment from 700Hz to 14KHz, with a continuous "Q" from .7 to 5., engaged with the MF switch.
HF EQ
+/-15dB adjustment at 4.7, 6.8, 12, and 25kHz, independent HF engage, selectable classic bell or accelerated shelf curves
All EQ In
Enables all EQ Bands (Individual bands must still be engaged)
Comp In
Engages Compressor section
Mic Pre
Frequency Response:
Main Output, no load
–3 dB @ 2 Hz
–3 dB @ 160 kHz
Noise:
Measured at Main Output, unweighted, 22Hz-22kHz,
Terminated 150 Ohms.
With gain at unity better than –92 dBu
With gain at 66 dB better than –56 dBu
Equivalent Input Noise better than –123 dBu
Gain:
Unity to +66dB in 6 dB steps,
Trim continuously adjustable from –6dB to +6dB
Line Input:
Trim continuously adjustable from –6dB to +6dB
Maximum Output Level:
Maximum output from 20 Hz to 40 kHz is +25 dBu.
Phantom Power:
48 Volts DC +/- 1%
Total Harmonic Distortion and Noise:
@ 1kHz, +20 dBu output: Better than 0.002%
As above, Silk Engaged: Better than 0.2% Second Harmonic
@ 20Hz, +20 dBu out Better than 0.004%
@ 20Hz, +20 dBu out Better than 0.020%
IM Distortion: Better than 0.002%
Slew rate Better than 4 V/uS
High Pass Filter:
Frequency: Continuously Variable from 20 Hz to 250Hz
Slope: 12 dB/Octave Bessel
مشخصات پری امپ و پردازشگر | |
نوع پری امپ | Solid State |
تعداد کانال | 1 |
نوع طراحی | رو میزی و رک |
پاسخ فرکانسی | 2Hz to 160kHz |
فانتوم پاور | دارد |
اکولایزر | دارد |
کمپرسور | دارد |
دیسر DeEsser | |
دیتر Dither | |
تعداد ورودی آنالوگ | 1 x XLR (Mic), 1 x XLR (Line), 1 x 1/4" (Hi-Z) |
تعداد خروجی آنالوگ | 1 x XLR |
ورودی / خروجی دیجیتال | |
تعداد اسلات رک | 2U |
طول | 254 میلیمتر |
عرض | 482 میلیمتر |
ارتفاع | 88 میلیمتر |
وزن | 7.4 کیلوگرم |